Yaskawa GPD503 Drive - Manual (Page 132)

CONSTANT SET FACTORY USER PARA.
NUMBER DATA NAME DIGIT DATA FUNCTION SETTING SETTING REF.
Sn-15 Terminal 5 – – 00 – Selects terminal 5 function 03 2.19, 2.2B,
✤ Function FF (Auto/Man select) 2.8D, 2.11,
(00) * 2.12B, 2.15,
2.24, 2.28A
Sn-16 Terminal 6 – – 00 – Selects terminal 6 function 04 2.19, 2.2B,
✤ Function FF (multi-step frequency ref. 2.8D, 2.11,
select) (03) * 2.12B, 2.15,
2.24, 2.28A
Sn-17 Terminal 7 – – 00 – Selects terminal 7 function 06 2.19, 2.2B,
✤ Function FF (Jog) 2.8D, 2.11,
(04) * 2.12B, 2.15,
2.24, 2.28A
Sn-18 Terminal 8 – – 00 – Selects terminal 8 function 08 2.19, 2.2B,
✤ Function FF (external baseblock by N.O. 2.8D, 2.11,
contact input) (06) * 2.12B, 2.15,
2.24, 2.28A
Sn-19 Multi-function – – 00 – Selects terminal 16 function 00 2.18, 2.2C,
Analog Input FF 2.8C, 2.22,
(Term. 16) 2.24, 2.29
Sn-20 Multi-function – – 00 – Selects multi-function 00 2.21, 2.22,
Output 1 FF contact (terminals 9 & 10) 2.23
function
Sn-21 Multi-function – – 00 – Selects multi-function open 01 2.21, 2.22,
Output 2 FF collector (terminal 25) 2.23
function
Sn-22 Multi-function – – 00 – Selects multi-function open 02 2.21, 2.22,
Output 3 FF collector (terminal 26) 2.23
function
Sn-25 Analog Speed XXXX 0 Plus/minus values of fre- 0000 Separate
Setter (AI-14B) quency reference sum Option
enabled Instruction
Sheet
1 Plus value of frequency
reference sum enabled
XXXX – Not Used – –
* ( ) are constant settings after 3-wire Reset Code has been entered.
✤ Settings of these four constants MUST be in ascending value.
Table A1-3. System Constants (Sn-XX) - Continued
CONSTANT SET FACTORY USER PARA.
NUMBER DATA NAME DIGIT DATA FUNCTION SETTING SETTING REF.
A1-8