HEIDENHAIN iTNC 530 (340 49x-04) Touch Probe Cycles - Manual (Page 68)

68 3 Touch Probe Cycles for Automatic Workpiece Inspection
3.2 Pr
eset
ting aut
o
matically
Characteristics common to all touch probe
cycles for datum setting
Datum point and touch probe axis
From the touch probe axis that you have defined in the measuring
program the TNC determines the working plane for the datum:
You can also run the touch probe cycles 408 to 419 during
an active rotation (basic rotation or Cycle 10).
Active touch probe axis Datum setting in
Z or W X and Y
Y or V Z and X
X or U Y and Z