Introduction – HEIDENHAIN iTNC 530 (340 49x-04) Touch Probe Cycles User Manual
Page 13
HEIDENHAIN iTNC 530
13
1.1 General Information on Touch Probe Cycles ..... 20
Touch probe cycles in the Manual and Electronic Handwheel modes ..... 21
Touch probe cycles for automatic operation ..... 21
1.2 Before You Start Working with Touch Probe Cycles ..... 23
Maximum traverse to touch point: MP6130 ..... 23
Safety clearance to touch point: MP6140 ..... 23
Orient the infrared touch probe to the programmed probe direction: MP6165 ..... 23
Consider a basic rotation in the Manual Operation mode: MP6166 ..... 24
Multiple measurement: MP6170 ..... 24
Confidence interval for multiple measurement: MP6171 ..... 24
Touch trigger probe, probing feed rate: MP6120 ..... 25
Touch trigger probe, rapid traverse for positioning: MP6150 ..... 25
Touch trigger probe, rapid traverse for positioning: MP6151 ..... 25
KinematicsOpt: Tolerance limit in Optimization mode: MP6600 ..... 25
KinematicsOpt, permissible deviation of the calibration ball radius: MP6601 ..... 25