HEIDENHAIN iTNC 530 (340 49x-04) Touch Probe Cycles - Manual (Page 171)

HEIDENHAIN iTNC 530 171
4.1 Kinematic Measur
ement with TS
T
ouc
h Pr
obes (Option KinematicsOpt)
 Start angle A axis Q411 (absolute): Starting angle in
the A axis at which the first measurement is to be
made
 End angle A axis Q412 (absolute): Ending angle in the
A axis at which the last measurement is to be made
 Angle of incid. A axis Q413: Angle of incidence in
the A axis at which the other rotary axes are to be
measured
 Number meas. points A axis Q414: Number of probe
measurements with which the TNC is to measure the
A axis
 Start angle B axis Q415 (absolute): Starting angle in
the B axis at which the first measurement is to be
made
 End angle B axis Q416 (absolute): Ending angle in the
B axis at which the last measurement is to be made
 Angle of incid. in B axis Q417: Angle of incidence
in the B axis at which the other rotary axes are to be
measured
 Number meas. points B axis Q418: Number of probe
measurements with which the TNC is to measure the
B axis
 Starting angle in C axis Q419 (absolute): Starting
angle in the C axis at which the first measurement is
to be made
 End angle C axis Q420 (absolute): Ending angle in the
C axis at which the last measurement is to be made
 Angle of incid. in C axis Q421: Angle of incidence
in the C axis at which the other rotary axes are to be
measured
 Number meas. points C axis Q422: Number of probe
measurements with which the TNC is to measure the
C axis