HEIDENHAIN iTNC 530 (340 49x-04) Touch Probe Cycles - Manual (Page 172)

172 4 Touch Probe Cycles for Automatic Kinematic Measurement
4.1 Kinematic Measur
ement with TS
T
ouc
h Pr
obes (Option KinematicsOpt)
Log function
After running Cycle 451, the TNC makes a measuring log containing
the following information:
„ Creation date and time of the log
„ Path of the NC program from which the cycle was run
„ Mode used (0=Check/1=Optimize)
„ Active kinematic number
„ Entered calibrating ball radius
„ For each measured rotary axis:
„ Start angle
„ End angle
„ Number of measuring points
„ Angle of incidence
„ Measuring circle radius
„ Ascertained backlash
„ Measured dispersion
„ Optimized dispersion
„ Compensation values
„ Valuations