HEIDENHAIN iTNC 530 (340 49x-04) Touch Probe Cycles - Manual (Page 125)

HEIDENHAIN iTNC 530 125
3.3 A
u
to
matic W
o
rk
piece Measur
ement
 Center in 1st axis Q273 (absolute value): Center of
the pocket in the reference axis of the working plane.
 Center in 2nd axis Q274 (absolute value): Center of
the pocket in the minor axis of the working plane.
 First side length Q282: pocket length, parallel to
the reference axis of the working plane.
 Second side length Q283: pocket length, parallel to
the secondary axis of the working plane.
 Measuring height in the touch probe axis Q261
(absolute): Coordinate of the ball tip center (= touch
point) in the touch probe axis in which the
measurement is to be made.
 Setup clearance Q320 (incremental): Additional
distance between measuring point and ball tip. Q320
is added to MP6140.
 Clearance height Q260 (absolute): Coordinate in the
touch probe axis at which no collision between tool
and workpiece (fixtures) can occur.
 Traversing to clearance height Q301: Definition of
how the touch probe is to move between the
measuring points:
0: Move at measuring height between measuring
points
1: Move at clearance height between measuring
points
 Max. size limit 1st side length Q284: Maximum
permissible length of the pocket.
 Min. size limit 1st side length Q285: Minimum
permissible length of the pocket.
 Max. size limit 2nd side length Q286: Maximum
permissible width of the pocket.
 Min. size limit 2nd side length Q287: Minimum
permissible width of the pocket.
 Tolerance value for center 1st axis Q279:
Permissible position deviation in the reference axis of
the working plane.
 Tolerance value for center 2nd axis Q280:
Permissible position deviation in the minor axis of the
working plane.
X
Y
Q287
Q285
Q274 ±Q280
Q273 ±Q279
Q283 Q286
Q282
Q284
X
Z
Q261
Q260
MP6140
+
Q320