HEIDENHAIN iTNC 530 (340 49x-04) Touch Probe Cycles - Manual (Page 18)

18
5.1 Tool Measurement with the TT Tool Touch Probe ..... 174
Overview ..... 174
Setting the machine parameters ..... 174
Entries in the tool table TOOL.T ..... 176
Display the results of measurement ..... 177
5.2 Available Cycles ..... 178
Overview ..... 178
Differences between Cycles 31 to 33 and Cycles 481 to 483 ..... 178
Calibrating the TT (touch probe cycle 30 or 480, DIN/ISO: G480) ..... 179
Measuring the tool length (touch probe cycle 31 or 481, DIN/ISO: G481) ..... 180
Measuring the tool radius (touch probe cycle 32 or 482, ISO: G482) ..... 182
Measuring the tool radius (touch probe cycle 33 or 483, ISO: G483) ..... 184
5 Touch Probe Cycles for Automatic Tool Measurement ..... 173