HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 91)

91
End-f
ace mac
hining
Contour starting point/End-face rapid traverse G100
Geometry: G100 defines the starting point of an end-face contour.
Parameters
X, C:
Target point (diameter), end angle – angle direction: see
support graphics
XK,YK: Target point (Cartesian coordinates)
Machining: The tool moves at rapid traverse along the shortest path
to the target point.
Parameters
X, C:
Target point (diameter), end angle – angle direction: see
support graphics
XK,YK: Target point (Cartesian coordinates)
Z: Target point – default: current Z position
Danger of collision!
With G100 the tool moves in a linear motion – even if you only
program “C“. Use G110 to position the workpiece at a certain
angle.