HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 5)

5
Setup
Display fields for machine data
Position display
Display of the current distance between tool tip
and workpiece datum in X and Z, or the current
position of the C axis.
Distance-to-go
MANUALplus calculates the distance remaining
from the current position to the target position of
the active traversing command.
Spindle utilization
Utilization of the spindle motor
T display
• T number of the inserted tool
• Tool compensation values
F display
• Symbol for cycle status
• Upper field: programmed value
• Lower field: setting of override control and actual
feed rate
S display
• Symbol for spindle status
• Upper field: programmed value
• Lower field: setting of override control and actual
spindle speed
• With position control (M19): spindle position
• Gear range (small number next to “S“)
• “S“ highlighted: S display is valid for the driven tool
Setup
Entering machine data (“Set S, F, T“)
With “Set S, F, T“ you enter the machine data required for manual
operation, as well as the maximum speed and tool angle.
Note with driven tools:
• MANUALplus recognizes from the tool description whether a driven
tool is used.
• If the active tool is a driven tool, the displayed spindle and machine
tool data refer to the driven tool.
• Milling cutters always qualify as “driven tools“.
• After system start, MANUALplus assumes that the tool
that was last used is still inserted in the tool holder. If this
is not the case, you must inform the control of the tool
change.
• At a “constant cutting speed“, MANUALplus calculates the
spindle speed depending on the tool tip position. The smaller
the diameter of the tip, the higher the spindle speed. The
“maximum spindle speed D“, however, is never exceeded.