HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 36)

35
Milling cycles
ICP figure axial
ICP figure radial
Depending on the parameters, the cycle either mills a contour or roughs/
finishes a pocket on the end face/lateral surface.
Information on the cycle parameters:
U:
Overlap factor
• No entry: Contour milling
• U>0: Pocket milling – (minimum) overlap of the milling
paths = U*cutter diameter
H: Cutting direction – default: 0
• H=0: Up-cut milling
• H=1: Down-cut milling
J: Contour milling:
• J=0: On the contour
• J=1: Inside
• J=2: Outside
Pocket milling:
• J=0: From the inside out
• J=1: From the outside in
O: Milling procedure (only for pocket milling) – default: 0
• O=0: Roughing
• O=1: Finishing
ICP figure axial
ICP figure radial