HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 105)

105
Lat
er
al-surf
ace mac
hining
Figure definition lateral-surface rectangle G315
G315 defines a rectangle on a lateral surface. Program this figure
together with G794.
Parameters
Z, C:
Center point, angle of the center point
CY: Center point as length value
A: Angle – reference: see support graphics
K: Rectangle length
B: Rectangle width (height)
R: Chamfer/rounding
• R<0: Chamfer length
• R>0: Rounding radius
Figure definition lateral-surface polygon G317
G317 defines a polygon on a lateral surface. Program this figure together
with G794.
Parameters
Z, C:
Center point, angle of the center point
CY: Center point as length value
Q: Number of edges (3
† Q † 127)
A: Angle – reference: see support graphics
K: Width across flats (KW)/length
• K<0: Width across flats
• K>0: Edge length
R: Chamfer/rounding
• R<0: Chamfer length
• R>0: Rounding radius