HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 115)

115
Milling tools
Milling tools
Tool parameters
X, Z: Setup dimensions
I: Cutter diameter
WO: Tool orientation (number shown in graphic support window)
K: Number of teeth
DX/DZ: Wear compensation
Q: (Reference to) tool text
MD: Direction of rotation (3=M3; 4=M4) default: not assigned
TS: Cutting speed – default: not defined
TF: Feed rate per tooth – default: not defined
PT: Tool life – default: not defined
RT: Rem. dwell: Remaining tool life (display field)
PZ: Number of units – default: not defined
RZ: Remaining pieces (display field)
• When milling with “constant cutting speed”,
MANUALplus calculates the spindle speed
from the “cutter diameter I”.
• The “Number of teeth K“ is evaluated in
“G913 Feed rate per tooth“.
• I is necessary to show the tool tip in graphic
simulation.