HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 21)

21
Recessing cycles
ICP recessing radial
ICP recessing axial
With ICP cycles, you define the machining parameters within the
cycle description and specify the contour to be machined in an ICP
macro.
Recessing: The cycle machines the area defined by the “start point X,
Z” and the “ICP contour N”.
Finishing: The cycle finishes the contour area defined by “ICP contour N”.
Recessing:
• “Cutting width P” is defined: infeeds
† P.
• “Cutting width P” is not defined:
Infeeds † 0.8*cutting width of tool.
Finishing: The tool returns to the ”start point X, Z” at the end
of the cycle.