HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 15)

15
Single cuts
Rounding
The cycle produces a rounding arc that is dimensioned relative to the
corner of the workpiece contour. When the cycle is completed, the
tool remains at the cycle end position.
Contour rounding (“with return“)
In this cycle, the tool approaches the workpiece, machines the
rounding arc and returns to the “start point“ at the end of the cycle.
• Cutting radius compensation is effective in the “with
return“ mode.
• The direction of tool traverse depends on the algebraic sign
for the parameter “element position J“ (see support
graphics).
Chamfer
The cycle produces a chamfer that is dimensioned relative to the
corner of the workpiece contour. When the cycle is completed, the
tool remains at the cycle end position.
Contour chamfer (“with return“)
In this cycle, the tool approaches the workpiece, machines the
chamfer and returns to the “start point“ at the end of the cycle.
• Cutting radius compensation is effective in the “with
return“ mode.
• The direction of tool traverse depends on the algebraic sign
for the parameter “element position J“ (see Help graphic).
• Parameter combinations for defining the chamfer: see
support graphics.