HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 30)

30
Dr
illing and bor
ing cy
cles
Drilling axial
Drilling radial
This cycle drills a hole on the end face/lateral surface of the workpiece.
Information on the cycle parameters:
C:
Spindle angle (C-axis position) – default: current spindle position
Z1/X1: Start point drill – no input: drilling will start from position Z/X
E Dwell time (for chip breaking at end of hole) –
default: 0
AB Drilling lengths – default: 0
V: Drilling variants – default: 0
• 0: Without feed reduction
• 1: Reduction for drilling through
• 2: Reduction for spot drilling
• 3: Reduction for spot drilling and drilling through
• If you program both “AB” and “V”, the feed rate is reduced
for spot and through drilling (reduction factor: 50%).
• MANUALplus uses the tool parameter “driven tool” to deter-
mine whether the programmed spindle speed and feed rate
apply to the spindle or the driven tool.
Drilling axial
Drilling radial