HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 102)

102
Lat
er
al-surf
ace mac
hining
Lateral-surface linear groove G792
G792 mills a groove from the current tool position to the end point.
Tilt the spindle to the desired angle before calling G792.
Parameters
Z, C:
Target point, target angle
K: Groove length – referenced to the center of the cutter
A: Groove angle – reference: see support graphics
Z: Milling surface (diameter)
J: Milling depth – default: begin milling at the current tool position
P: Maximum infeed – default: total depth in one infeed
F: Infeed rate (for depth infeed) – default: active feed rate