HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 20)

20
Recessing cycles
Recessing radial
Recessing axial
Recessing (expanded): The cycle machines the defined area, taking
the optional contour elements into account.
Finishing (expanded): The cycle finishes the defined contour section,
taking the optional contour elements into account.
Information on the cycle parameters:
R:
Rounding (on both sides of contour valley)
B1, B2: Chamfer or rounding (B1 contour start; B2 contour end)
• B>0: Rounding radius
•
B<0: Chamfer width
Recessing:
• “Cutting width P” is defined: infeeds
† P.
• “Cutting width P” is not defined:
Infeeds
† 0.8*cutting width of tool.
• The cycle does not take oversizes into account in the
normal mode.
Finishing: The tool returns to the ”start point X, Z” at the end
of the cycle.