HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 52)

52
Rapid traverse G0
The tool moves at rapid traverse along the shortest path to the target
point.
Parameters
X, Z:
Target point (X diameter)
G0 is also used in contour descriptions for defining the start point.
T
ool positioning
without machining
Tool change point G14
The slide moves in rapid traverse to the tool change point. In setup
mode, define permanent coordinates for the tool change.
Parameters
Q:
Sequence – default: 0
• 0: Diagonal path of traverse
• 1: First in X axis, then in Z
• 2: First in Z axis, then in X
• 3: X axis only
• 4: Z axis only