HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 9)

9
Teach-in (Cycle mode)
In Teach-in mode you machine a workpiece step by step with
cycles. MANUALplus ”memorizes“ how the workpiece was ma-
chined and stores the working steps in a cycle program.
DIN macros are programmed in the DIN editor and then integrated in
the DIN cycle.
Program run
In the machining mode, you use already-programmed cycle programs
and DIN programs for parts production. You can check your programs
befor running them using the ”Graphic simulation” function.
Program execution
With the function keys, you can determine whether a program is to be
executed continuously, cycle by cycle, or block by block. Independent
of this setting, program run will be interrupted immediately if you
press ”Cycle stop”.
Compensation: You can enter tool compensation values and additive
corrections during program run (function key ”Tool/Add correct.”).
Base blocks: The program-block display is switched to base blocks.
The traversing and switching commands are now shown in ”DIN
format“.
• MANUALplus starts program run from the
cycle (or DIN block) that is highlighted.
The starting position is not changed by a
previous graphic simulation.
• DIN programs: When selecting the
startup block, ensure that the machine
data (S, F, T) are set before the control
reaches the first traversing command.
Danger of collision!
MANUALplus does not convert faulty cy-
cles. It is therefore very important that you
check whether a cycle program resulting in
an error message can be run.
T
eac
h-in,
Pr
ogr
am r
u
n