HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 71)

71
Recessing cycle
Axial finishing cut G867
Radial finishing cut G868
G867/G868 finishes the contour area described by the tool position and
“X, Z“.
Tool position at end of cycle: cycle starting point.
Parameters
X, Z:
Target point (X as diameter)
E: Finishing feed rate – no input: active feed rate
Cutter radius compensation: is carried out
Axial contour finishing cut G863
Radial contour finishing cut G864
G863/G864 finishes the contour area described by the blocks following
the cycle call.
Tool position at end of cycle: cycle starting point.
Parameters
E:
Finishing feed rate
Cutter radius compensation: is carried out
Example: Contour finishing cut G863
Example: Finishing cut G868