HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 31)

31
Dr
illing and bor
ing cy
cles
Deep-drilling (pecking) axial
Deep-drilling (pecking) radial
The bore hole on the end face/cylindrical surface is drilled in several
passes. After each pass, the drill retracts and, after a dwell time,
advances again to the first pecking depth, minus the safety distance.
Information on the cycle parameters:
C:
Spindle angle (C-axis position) – default: current spindle position
Z1/X1: Start point drill – no input: drilling will start from position Z/X
P: 1st hole depth – no input:
hole will be drilled in one pass
IB: Hole depth reduction value – default: 0
JB: Minimum hole depth – default: 1/10 of P
B: Return length – default: retract to “start point”
E Dwell time – default: 0
AB Drilling lengths – default: 0
V: Drilling variants – default: 0
• 0: Without feed reduction
• 1: Reduction for drilling through
• 2: Reduction for spot drilling
• 3: Reduction for spot drilling and drilling through
• If you program both “AB” and “V”, the feed rate is reduced
for spot and through drilling (reduction factor: 50%).
• MANUALplus uses the tool parameter “driven tool” to de-
termine whether the programmed spindle speed and feed
rate apply to the spindle or the driven tool.
Deep-drilling axial
Deep-drilling radial