HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 8)

8
Cycles
When using cycles, you need to:
Set the spindle speed
Set the feed rate
Insert tool, define T number and check tool data
Approach cycle start point
Select the cycle, define the parameters, and
grapchically simulate the cycle execution
Run the cycle
Manual mode
With manual workpiece machining, you move the axes with the
handwheels or jog controls. You can also use cycles, for example, for
machining complex contours. The paths of traverse and the cycles,
however, are not stored.
After switch-on and traversing the reference marks, MANUALplus is
always in ”Manual“ mode. This mode remains active until you select
”Teach-in” or ”Program run”. You can return to Manual mode with the
”Menu“ key.
Before you start machining, you should set the workpiece datum
using ”Set axis values“ to ensure that the display shows the correct
position.
Tool change
You need to enter the T number and check the tool parameters.
Handwheel operation
The Handwheel resolution selector switch on the machine operating
panel enables you to set the traverse per handwheel increment.
Jog operation (joystick)
The feed rate is defined in ”Set S, F, T“ and the feed rate for rapid
traverse in the parameter ”Machine parameters – Feeds“.
Manual mode