HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 112)

112
Recessing tools
Recessing tools
Tool parameters
X, Z: Setup dimensions
R: Cutting radius
WO: Tool orientation (number shown in graphic support window)
K: Cutting width
DX, DZ: Wear compensation
DS:
Special compensation
Q: (Reference to) tool text
MD: Direction of rotation (3=M3; 4=M4) default: not assigned
TS: Cutting speed – default: not defined
TF: Feed rate – default: not defined
PT: Tool life – default: not defined
RT: Rem. dwell: Remaining tool life (display field)
PZ: Number of units – default: not defined
RZ: Remaining pieces (display field)
• With recessing tools, you define the position of the refer-
ence point with “WO”.
• “DX and DZ” compensate for wear on the two sides of the
tool tip that lie next to the “reference point”. “DS” compen-
sates for wear on the third side of the tool tip (see figure at
bottom right).
• “K” is evaluated if the corresponding parameter is not defined
in the recessing cycle.
WO = 3 WO = 1
DS DS DZ DZ
DX DX