HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 46)

46
ICP Programming
Chamfer
Rounding
The corner point is defined by “XS, ZS”. You need only enter the “chamfer
width B”/”rounding radius B”.
Turning contours: If the first element of the ICP contour is a chamfer/
rounding, it is necessary to specify the position of the chamfer/
rounding with “J”.
Parameters
XS, ZS:
Contour corner point
B: Chamfer width / rounding radius
J: Element position
• J = 1: Transverse element in +X direction
• J=–1: Transverse element in –X direction
• J = 2: Longitudinal element in +Z direction
• J=–2: Longitudinal element in –Z direction
F: Special feed
Chamfer/rounding for turning contours
Chamfer/rounding for end face and lateral surface
contours