HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 23)

23
Recessing cycles
ICP recess turning radial
ICP recess turning axial
With ICP cycles, you define the machining parameters within the
cycle description and specify the contour to be machined in an ICP
macro.
Recess turning: The cycle machines the area defined by the “start point
X, Z” and the “ICP contour N” with alternating recessing and roughing
motions.
Recess turning – finishing: The cycle finishes the contour area defined by
“ICP contour N”. The cycle machines the material defined in “Oversizes I,
K“.
Recess turning: Which points need to be defined?
• Falling contours: Only the “start point X, Z“ – not the “con-
tour beginning point X1, Z1“
• Rising contours: The “start point X, Z“ and the “contour be-
ginning point X1, Z1“
Finishing:
• The tool returns to the “start point X, Z” at the end of the
cycle.
• In “Oversizes I, K“, define the material that is machined in the
finishing cycle.