HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 39)

39
Dr
illing and milling pat
te
rn
s
Pattern linear axial
The function “Pattern linear axial“ can be activated in drilling cycles
(drilling, pecking, tapping) and milling cycles (groove, ICP contour) to
machine a hole or milling pattern arranged at regular spacing in a
straight line on the end face.
You describe the “Pattern start point/end point“ and the individual
pattern positions with the following parameter combinations:
• Pattern start point:
• X1, C1 or
• XK, YK
• Pattern positions:
• Ii, Ji and Q
• I, J and Q
• Hole pattern: MANUALplus generates the commands M12
and M13 (tighten/release shoe brake) under the following
conditions: the drilling/pecking tool must be “driven“ (Pa-
rameter “Tool driven H“) and the “Turning direction MD“ must
be defined.
• ICP milling contours: When the contour start point is not the
coordinate system origin, the distance “contour start point –
coordinate system origin“ is added to the pattern position.