HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 100)

100
Lat
er
al-surf
ace mac
hining
Lateral-surface linear path cycle G111
Geometry: G111 defines a path on a lateral-surface contour.
Parameters
Z, C:
Target point, target angle – angle direction: see support graphics
CY: Target point as length value
A: Angle of inclination – Reference: see support graphics
Q: Point of intersection – default: Q=0
• Q=0: Near point of intersection
• Q=1: Remote point of intersection
B: Chamfer/rounding
• B left undefined: Tangential transition
• B=0: Non-tangential transition
• B>0: Rounding radius
• B<0: Chamfer width
Machining: The tool moves at the feed rate along a linear path to the
target point.
Parameters
Z, C:
Target point, target angle – angle direction: see support graphics
CY: Target point as length value
X: Target point (X as diameter) – (infeed)