HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 18)

18
Clearance cycle group
ICP longitudinal contour-parallel
ICP transverse contour-parallel
With ICP cycles, you define the machining parameters within the
cycle description and specify the contour to be machined in an ICP
macro.
Roughing: The cycle machines the area defined by the “start point X,
Z” and the “ICP contour N“ parallel to the contour.
Finishing: The cycle finishes the contour area defined by “ICP contour N”.
Danger of collision!
• If the setup and tip angles of the tool have not been de-
fined, the tool plunge-cuts into descending contours at the pro-
grammed plunging angle.
• If the setup and tip angles of the tool have been defined,
the tool plunge-cuts at the maximum possible angle. In this
case, the resulting contour will not be completely finished
and may need to be reworked.