HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 114)

114
Dr
illing t
ools
Drilling tools
Tapping tools
Tool parameters
X, Z: Setup dimensions
WO: Tool orientation (number shown in graphic support window)
I: Hole diameter / thread diameter
B: Tip angle – range: 0°
†180°
F: Thread pitch
DX/DZ: Wear compensation
H: Tool driven (0=not driven; 1=driven) default: 0
Q: (Reference to) tool text
MD: Direction of rotation (3=M3; 4=M4) default: not assigned
TS: Cutting speed – default: not defined
TF: Feed rate – default: not defined
PT: Tool life – default: not defined
RT: Rem. dwell: Remaining tool life (display field)
PZ: Number of units – default: not defined
RZ: Remaining pieces (display field)
Drilling tools
• When drilling with“constant cutting speed“, MANUALplus
calculates the spindle speed from the “hole diameter I“.
• I and B are necessary to show the tool tip in graphic simulation.
Tapping tools: “F“ is evaluated if the thread pitch parameter
is not defined in the tapping cycle.
Drilling tools
Tapping tools