HEIDENHAIN MANUALplus 4110 Pilot - Manual (Page 57)

57
Compensate right tool tip G150
Compensate left tool tip G151
With recessing tools, the “tool orientation“ function defines whether the
tool reference point is set at the left or the right side of the tool tip.
G150: Reference point at right of tool tip
G151: Reference point at left of tool tip
G150/G151 is effective from the block in which it is programmed and
remains effective until
• the next tool change
• the end of program.
Cor
rections,
other G Functions
Dwell time G4
MANUALplus interrupts the program run for the
programmed length of time before executing the next
program block. If G4 is programmed together with a
path of traverse in the same block, the dwell time
only becomes effective after the path of traverse has
been executed.
Parameters
F:
Dwell time – Range: 0 s < F < 999 s
Deactivate protection zone G60
The function G60 cancels a programmed monitoring
of the protection zone. G60 is only effective in the
block in which it is programmed.
Additive correction G149
To activate the additive correction function, program G149 followed by a
“D number“ (for example: G149 D901). “G149 D900“ resets the additive
correction function.
Additive corrections are effective from the block in which G149 is
programmed and remain effective until
• the next “G149 D900“
• the next tool change
• the end of program.
Parameters
D:
Additive correction – default: D900 – Range: 900 to 916