HEIDENHAIN ND 1300 VED and Crosshair Systems - Manual (Page 99)

79
6
Measuring
2 Probe two or more points well distributed
along the left side of the part, and then press the
Finish button. The line feature will be added to the
Features list.
3 Touch the Measure Point icon, and the touch
the line probed on the left side of the part in the
Features list and then press the Enter key. A check mark will appear next to the line and the skew line will
be highlighted in the Features list.
4 Press the Enter key. A check mark will appear next to the skew line. Press the Finish key to complete
the point construction. The datum point will be added to the Features list.
Establishing a Measurement Reference