HEIDENHAIN ND 1300 VED and Crosshair Systems - Manual (Page 256)

236 QC-300 Series User’s Guide
Minimum setup requirements
In most cases, the QC-300 will be provided by a Metronics distributor or an OEM and will be config-
ured and ready to use. Setup by the end-user will be unnecessary. However, if some setup is required, a
minimum sequence of steps should be performed in the order shown by the block diagram. Each block
describes a setup task and refers to pages where detailed instructions are presented.
A variety of optional setup steps can be performed after the minimum setup to specify display, reporting
and other parameters. These optional and all other setup parameters and screens are described in detail in
the remainder of this chapter.
Familiarize yourself with the methods of accessing and using the Setup menu described
on earlier pages before performing these minimum or additional optional setup steps.
Page 238
Page 260
Page 46
Page 49
Page 257
Page 252
Page 241
Page 242
Page 261