HEIDENHAIN ND 1300 VED and Crosshair Systems - Manual (Page 212)

192 QC-300 Series User’s Guide
Selecting image files
Image files can be located on either of two drives:
• An external USB thumb drive (A:)
• The internal flash drive (C:)
Files are selected by choosing the source drive, and then selecting the desired file(s).
An external USB drive will be recog-
nized by the system if it is inserted into
the USB port when the file handler is
launched. When the drive is recog-
nized, the USB drive letter (A:) will be
displayed in the lower left corner of the
file handler toolbar. The number of im-
age files that can be stored on an external
USB thumb drive is only limited by the
capacity of the drive. Image files are
typically smaller than 200 KB.
The internal C: drive will store up to 40 image files. Image files are retained on the C: drive until deleted
by the user. When image file storage spans multiple measurement sessions, the file names of image files
on the C: drive might not match the file names shown in the feature list.
Selecting a drive
The drive letter of the current
drive and file name of the selected
image are shown in the upper left
corner of the screen.
Touch a drive letter in the file
handler toolbar to select a differ-
ent drive and view its contents.
USB drive USB drive letter
Touch a drive letter... to select a drive