HEIDENHAIN ND 1300 VED and Crosshair Systems - Manual (Page 190)

170 QC-300 Series User’s Guide
Measure a feature (including a message)
Feature measurements are described in Chapter 6: Measuring. In this example, the largest hole in the QC
Quickie slide is measured.
First, you may optionally create a message that prompts the user to measure the hole. Press the Finish key
to complete the message.
Perform the measurement; touch
the measure icon, collect the re-
quired points and press Finish.
Touch the message icon... to include a user prompt message... then press the Finsh key to return
to a measurement screen
Touch the desired measure icon... collect points and press Finish