HEIDENHAIN ND 1300 VED and Crosshair Systems - Manual (Page 247)

227
10
Communication
Printing a report
Feature measurement data or record of QC-300 system settings can be printed at the USB port.
Printing feature measurement data
Feature measurement data can be printed in the following formats:
• None No data will be printed
• Select User will be prompted to select the data that will be printed
• Report A standard report of all feature data or a tolerance report of only features that have
tolerances applied will be printed
• Screen Only the encoder values currently shown on the DRO screen (current position) will
be printed. Screen values can be printed each time the print key is pressed, or
can be buffered and printed when an entire page of values is ready.
To print feature measurement data:
1 Touch the question mark Icon and display the setup
menu, then display the Print setup screen.
2 Verify that the desired data is specified in the Print
Button choice field. None, Select, Report or Screen can
be specified. If Screen is specified, set the Buffer Page
choice field as desired. In this ex-
ample, the Report is specified.
3 Verify that the Serial Device is specified in the Des-
tination field. In this example, the file will be printed to
a USB printer, so the USB Printer
is specified.
4 Verify that the desired report is specified in the Report Type setup choice field. Standard or Tolerance
can be specified. In this example, a Standard report is specified.
5 Specify other settings that are consistent with the computer application’s requirements.
6 Press the Finish key to exit the setup mode, and then press the Print key to send the data to the
printer.
Connecting a Printer and Printing Reports