HEIDENHAIN ND 1300 VED and Crosshair Systems - Manual (Page 122)

102 QC-300 Series User’s Guide
Point constructed from a slot
A point feature will be constructed at the center of a slot.
To construct a point from a slot:
1 Touch the Measure Point icon
2 Touch the slot feature
3 Press the Enter key
4 Press the Finish key
A point feature will be constructed at the center of the slot.
Point constructed from a rectangle
A point feature will be constructed at the center of a rectangle.
To construct a point from a slot:
1 Touch the Measure Point icon
2 Touch the rectangle feature
3 Press the Enter key
4 Press the Finish key
A point feature will be constructed at the center of the rectangle.
Point constructed from an angle
A point feature will be constructed at the apex of the angle.
To construct a point from an angle:
1 Touch the Measure Point icon
2 Touch the angle feature
3 Press the Enter key
4 Press the Finish key
A point feature will be constructed at the apex of the angle.