HEIDENHAIN ND 1300 VED and Crosshair Systems - Manual (Page 31)

11
2
Installation
Warranty registration form
The warranty registration form included in
the shipping carton should be completed and
mailed as soon as possible. Also record the
purchase and warranty information here so
that it will be readily available later to support
any necessary interactions with distributor or
factory technical support personnel.
The software version can be found in the
Hardware setup screen. Refer to Chapter 11: Setup for screen descriptions.
Repackaging for shipment
Repackage the QC-300 in the original packaging as received from the factory, or equivalent. It is not
necessary to ship the base when shipping the QC-300 for repair.
CAUTION
The original packaging must be duplicated and the LCD must be inserted face-up to
prevent damage to the LCD screen.
Pay special attention to the following instructions:
1 Connect any loose mounting hardware to the QC-300 instrument
2 Repackage the foam and cardboard carton inserts as originally shipped from the factory.
3 Place the QC-300 into shipping carton with the LCD facing up.
4 Replace the warranty card and slip sheets found at the top of the carton. The “Before you begin” slip
sheet should be inserted last.
What’s next?
Proceed to Chapter 11: Setup to configure your QC-300 for use. Follow the instructions for Essential Setup
as a minimum.
Warranty and Shipping