HEIDENHAIN ND 1300 VED and Crosshair Systems - Manual (Page 73)

5
Probes
53
NOTE
Contrast and
brightness can be
fine-adjusted by
one unit of con-
trast or brightness by touching
the slider bar on either side of
the slider control.
Adjusting video image contrast threshold
The contrast of an edge is shown by the height
of the gray bar on the right side of the screen
when the crosshair probe is positioned over
an edge. The contrast threshold required for
edge recognition is shown by the yellow ar-
row and must fall within the gray bar. When
the threshold adjustment is unlocked in the
VED setup screen, the contrast threshold is
increased or decreased by raising or lowering
the yellow arrow on a contrast bar.
Drag left to decrease brightness... and right to increase brightness
Touch left to adjust down 1 unit Touch right to adjust up 1 unit
Preparing to Use Probes
Adjust the contrast threshold by touching and sliding
the yellow arrow