HEIDENHAIN ND 1300 VED and Crosshair Systems - Manual (Page 142)

122 QC-300 Series User’s Guide
Line constructed from a rectangle
The line feature will be constructed from the radius center at one end of
the rectangle to the radius center at the other end.
To construct a line from a slot:
1 Touch the Measure Line icon
2 Touch the rectangle feature
3 Press the Enter key
4 Press the Finish key
The center line of the rectangle will be constructed.
Line constructed from multiple features
The best fit line through the center of multiple features can be con-
structed from any combination and any number of points, slots, circles,
and arcs.
To construct a line from multiple features:
1 Touch the Measure Line icon
2 Touch a feature
3 Press the Enter key
4 Repeat steps 2 and 3 for all features
5 Press the Finish key
The best fit line through the entire collection of features will be constructed.