HEIDENHAIN ND 1300 VED and Crosshair Systems - Manual (Page 28)

QC-300 Series User’s Guide
USB printer
port
Footswitch connector
Connecting an optional footswitch
The optional foot switch is connected to the RJ-45 connector
on the left side of the QC-300.
1 Verify that the QC-300 is off.
2 Connect the foot switch to the RJ-45 connector on the rear
connector panel.
Connecting a printer
The QC-300 supports certain HP USB printers. Printer models
must be specified when the QC-300 is ordered, or approved by
Metronics later.
1 Verify that the QC-300 and printer power are off. Connect the
USB printer to the USB Type A port on the side of the enclosure.
2 Make sure the USB cable plug is fully inserted.