Checkbox options – Grass Valley NV9649 v.1.1 User Manual
Page 58
46
Configuration
NV9649 Panel Configuration Page(s)
Checkbox Options
The checkbox options section is just below the panel options section, enclosed in the same
region:
A check in the box enables the option. Clearing the checkbox disables the option.
By default, all the check box options are clear.
The following items are the checkbox options:
•
User-Programmable ID.
Allows the Panel ID to be changed locally at the control panel (in menu mode).
Release Mode
Normal Release
This panel can release “locks” and “protects” set by the designated
user (at this panel or any other panel).
Force Release
This panel can release locks and protects set by any user.
Default
Destination
None
After a reset, the panel displays no destination device. (This is not
recommended.)
‹device›
The Panel uses the specified device as the destination after a reset.
(The ‘Default State’ button also returns the panel to this destina-
tion.)
Preset Monitor
None
The preset source video is not sent to a monitor.
‹device›
The preset source video for the selected destination appears on
the specified monitor (device).
Status Monitor
None
The current source video is not sent to a monitor.
‹device›
The current source video for the selected destination appears on
the specified monitor (device).
Salvo List
[none]
Salvo lists appear in the drop-down menu. A salvo list, as you might
think, is a list of salvos. The salvos in the list you choose are the sal-
vos the operator can choose in salvo mode.
Salvo lists are defined, in NV9000-SE Utilities, under the ‘Views’
pane, using the ‘Salvo Lists’ table and the ‘Salvo List Details’ table.
The NV9000 configuration might not have any salvo lists, in which
case ‘None’ is the only entry in the drop-down menu.
Default Name Set System Name
A list of “name sets” appears in the drop-down menu. The name
sets can be defined under the System Management pane of
NV9000-SE Utilities. Choose ‘System Name’ in this list if you do not
want, or do not care about, alternate device names. Do not choose
‘System Name’ if you are configuring any ‘Name Set Toggle’ but-
tons.