Grass Valley NV9649 v.1.1 - Manual (Page 123)

111
NV9649
User’s Guide
4 Use the knob now to scroll through the devices in the category until you see the desired
device in the preset display. (Device names consist of the category mnemonic followed by a
(usually) numeric suffix.
5 At any time, you can press a ‘Clear’ button to erase the preset entry you have selected. You
might have to press ‘Clear’ more than once.
Procedure B — Preset a Source Using a Keypad
To preset a source in the preset display of the NV9649 (server):
1 Ensure that the NV9649 is in source mode. Press a ‘Source Mode’ button or press a ‘SRC/DST
Mode’ button when the panel is in destination mode.
2 Use a category button to select the desired category. The selected category will be displayed
in the preset display. (The panel must have been configured with one or more category but-
tons.)
3 After choosing a category, use the panel’s keypad to “type in” the index of the desired device
contained in the category. For example, if the category is VTR and the device is VTR_12, type
in 1, then 2. (The panel must have been configured with one or more suffix buttons, which
are category buttons that provide suffixes.)
As you press keys of the keypad, a device that currently matches the string of indexes will be
displayed in the ‘Preset’ display.
Note also that you can use the knob to scroll forward or back from any point in the device
selection (starting at that whatever index you have entered so far).
 During device selection by keypad, certain keys in the keypad become disabled if it is not
possible to use the keys to perform further selection. For instance, if you have devices
numbered 1–16 in a category and you press 2 (e.g., VTR2), all keys in the keypad become
disabled because another digit would create an index of 20, 21, or similar, which is
beyond the range of 1–16.
4 At any time, you can press a ‘Clear’ button to go back one key press at a time as you require.
Procedure C — Assign a New Source to a NV9649 Source Button
To assign a new source to a source button of an NV9648’s control unit:
1 Ensure that the NV9649 is in source mode. Press the ‘Source Mode’ button or press a ‘SRC/
DST Mode’ button if the panel is in destination mode.
2 Use procedure A or procedure B described above to select (i.e., preset) the desired source.
3 Press an ‘Assign’ button on the NV9649.
4 Press the intended source button — in the intended control unit of the intended NV9648.
The software assigns the source selected at the NV9648 to that button. The source text
appears on the button’s LCD.