Procedure e - takes using source buttons, Procedure f - takes using quick source buttons, Procedure g – Grass Valley NV9649 v.1.1 User Manual
Page 124
112
Operation
Operating Methods
Procedure D — Assign a New Destination to a NV9649 Control Unit
To assign a new destination to a control unit of an NV9648:
1 Ensure that the NV9649 is in destination mode. Press the ‘Destination Mode’ button or press
a ‘SRC/DST Mode’ button if the panel is in source mode.
2 Select a destination device by (1) turning the knob or (1) selecting the category and device
index using a “keypad.”Use the method described under procedures A or B. But because you
have placed the NV9648 in destination mode, the method selects a destination.
3 Press an ‘Assign’ button on the NV9649.
4 Press any source button in the intended control unit of the intended NV9648. (To help you do
this, the source buttons of NV9648s — and only the source buttons — will be lighted.)
Note: because the NV9649 is in destination mode, the new destination mnemonic will immedi-
ately appear in the display of the intended control unit.
Procedure E — Takes Using Source Buttons
To perform a take to a single destination using an NV9648 control unit having standard source
buttons:
1 Press a source button in the control unit that corresponds to your intended destination.
The source becomes selected and the source button goes high-tally. The take button in the
same control unit goes high-tally red.
2 Press the take button. The take is completed.
Procedure F — Takes Using Quick Source Buttons
To perform a take to a single destination using an NV9648 control unit having quick source
buttons:
1 Press a quick source button in the control unit that corresponds to your intended destina-
tion.
2) That source is immediately taken to the destination of that control unit.
Procedure G
To perform a ‘Take All’:
1 Ensure that the NV9649 is in source mode. Press the ‘Source Mode’ button or press a ‘SRC/
DST Mode’ button if the panel is in destination mode.
2 Use procedure A or procedure B described above to select (i.e., preset) the desired source.
3 Press a ‘Take All’ button on the NV9649.
4 The source is taken to the destinations of all NV9648 control units, regardless of how many
there are.
Procedure H — Perform Device Selection by Category List
An NV9649 panel in server mode can be configured to allow operators to perform device selec-
tion by category list. When the NV9649 is so configured, it shows ‘CatLists’ in the ‘Info’ display.
This method involves using the panel’s knob.