Grass Valley NV9649 v.1.1 - Manual (Page 114)

102
Operation
Button Functions
Selection
In X-Y mode, the display shows levels and selection buttons select or deselect levels. In MD
mode, the display shows MD destinations and the selection buttons select or deselect MD desti-
nations. A selection button is high-tally when its associated level or MD destination is selected
and low-tally when it is not selected. Sometimes selection buttons are dark, meaning that the
level or MD destination is either not in use or not available.
X-Y Mode
When the panel is in X-Y mode, a selection button represents a virtual level present on the
alphanumeric display. Pressing one or more selection buttons selects (or deselects) the levels
associated with the buttons. A marker appears in the right-most column of the display for
selected levels.
 When all levels are selected, pressing a level button turns them all off except the one
pressed.
 If there are more than levels than buttons, scrolling is enabled.
Deselecting virtual levels in X-Y mode prepares a breakaway.
Hold mode preserves the level selection after a take.
MD Mode
When the panel is in MD mode, a selection button represents an MD destination. If there are
more MD destinations than selection buttons, scrolling is enabled. Pressing a selection button
selects the destination.
 Certain MD destinations might be unassigned. They appear blank in the display and the
corresponding buttons are dark.
When your panel is in hold mode, you can select more than one destination at once. If your
panel is not in hold mode, MD destinations are mutually exclusive: you can select only one at a
time.
If you have enabled ‘Hold’ mode,
1 Select one or more MD devices. Scroll the MD device display as needed.
2 Select a source.
3 Repeat steps 1 and 2 until your presets are complete.
4 Press ‘Take’. The selected MD devices remain selected.
If you have not enabled ‘Hold’ mode,
1 Select an MD device. Scroll the MD device display as needed.
2 Select a source.
3 Repeat steps 1 and 2 until your presets are complete.
4 Press ‘Take’. The selected MD devices become unselected.
If the configurer has turned on the option, you may redefine any MD destination. To do so is
simple: (1) select an MD destination on a selection button, (2) choose a destination that is not on
a selection button. You might have to navigate or scroll through a destination list to choose one.
Source
The button selects a specific source. The source name appears in the ‘Preset’ display.