Grass Valley NV9649 v.1.1 - Manual (Page 38)

26
Configuration
NV9649 Panel Configuration Page(s)
The use of category lists and the use of category pages are two mutually exclusive ways to
perform device selection.
The following items are the checkbox options:
• User-Programmable ID.
Allows the Panel ID to be changed locally at the control panel (in menu mode).
• Source Master Default.
Makes a control-level source the controlling device (or master device) by default. Otherwise,
the destination is the master by default. (The option is specifically for use with NV9000 series
machine control routers.)
“Source is master” is used for duplication, or broadcast routing, on a machine control level.
“Destination is master” is for machine-to-machine editing.
• Hide sources not configured on this panel.
Causes the names of source devices that are not presently configured for this particular
panel to be effectively hidden. When another panel changes the source to one not config-
ured for this panel, this panel displays asterisks instead.
• Use continuous scrolling.
If you check this box, the panel will scroll source or destination devices continuously (or
indefinitely). That is, the display will show the first device in the list following the last when
you are scrolling up, and will show the last device after the first if you are scrolling down.
If you leave this box unchecked, the panel will stop scrolling when it reaches either the
beginning or end of the list.
This option does not affect scrolling of salvos when the panel is in salvo mode.
• Server panel destination remove.
This option, when checked, prevents the NV9649 from being able to perform takes. Under
this option, ‘Take’ buttons do not illuminate when a source is preset.
The NV9649’s destination display and status display remain blank.
The underlying consideration is that takes are to be performed on the NV9648 clients only.
• Disable destination assignments.
If you check this option, the NV9649’s ability to assign destinations to NV9648 sections is dis-
abled.
• Quick preset take.
If you check this option, when the operator presets a source, all ‘Take’ buttons in all NV9648
control units go high-tally. The operator may then use the ‘Take’ button in the control unit
that corresponds to the destination to which the take is intended.
If you leave this option unchecked, the ‘Take’ buttons in the NV9648 units do not go high-
tally. Takes are not enabled on the NV9648s when the operator presets a source at the
NV9649.
• Use asterisk for breakaway.
If you check this option, the panel displays source names under breakaway with an asterisk
in the 8th character position.
This feature might not be suitable at some facilities. Therefore it is an option.