Grass Valley NV9649 v.1.1 - Manual (Page 53)

41
NV9649
User’s Guide
Checkbox Options
The checkbox options section is just below the panel options section, enclosed in the same
region:
A check in the box enables the option. Clearing the checkbox disables the option.
By default, all the check box options are unchecked except ‘Src/Dst Immediate Take’. That partic-
ular option is enabled by default.
The following items are the checkbox options:
• User-Programmable ID.
Allows the Panel ID to be changed locally at the control panel (in menu mode).
• Save Preset Default.
Makes ‘Save Preset’ mode active when the panel reverts to its default state (after a Default
State button is pressed, or when the panel is restarted).
 A ‘Save Preset’ button is needed only when you want the operator to be able to view or
change the mode.
• Hold Preset Default.
Makes “hold” mode active when the panel reverts to its default state (after a Default State
button is pressed, or when the panel is restarted).
 Note: a ‘Hold’ button is needed only when you want the operator to be able to view or
change the mode.
Default Name
Set System Name A list of “name sets” appears in the drop-down menu. The name
sets can be defined under the System Management pane of
NV9000-SE Utilities. Choose ‘System Name’ in this list if you do not
want, or do not care about, device name aliases.
Do not choose ‘System Name’ if you are configuring any ‘Name Set
Toggle’ buttons.
Multidest
Device Limit (Selectable in
multiples of 8) The number of multi-destination entries you are allowing. Make
this value equal to or greater than the number of MD devices you
need. The default, and lowest value, is 8. The maximum is 512.
(Elsewhere in the configuration, you will create a list of MD devices.
You can leave some MD destinations unassigned.)