Gasboy FMS KE200 - Manual (Page 87)

MDE-4465A KE200 Key Encoder/Maintenance Terminal Operation Manual · October 2007 Page A-1
Error Messages
Appendix A – Error Messages
0 ID FIELDS LOADED
An attempt to edit/view ID fields through the keypad was made when the KE200 is configured
for 0 ID fields.
BAD
Unsuccessful Fleetkey read/write attempt was executed by a terminal command.
COMMAND IS BLOCKED
An attempt was made to execute a terminal command that is currently being blocked by
another port or the keypad.
ENCODE FORMAT ERROR: xxx...xxx
ENCODE KEY command was executed on a key type whose format contains an error in the
field indicated.
---ENTRY ERROR---
Invalid data was entered at terminal.
INVALID COMMAND
Terminal command entered is unknown.
INVALID KEY TYPE
An attempt was made to perform maintenance on a Fleetkey, with a key type other than 0
(single key), 2 (vehicle key), or 3 (supervisor key).
INVALID SYSTEM ID
An attempt was made to perform maintenance on a Fleetkey whose system ID does not match
the one loaded into the KE200.
KEY READ FAILURE
KE200 detected a CRC error while reading a Fleetkey in the keypad mode.
KEY REMOVED
Fleetkey was removed during the update process.
KEY WRITE FAILURE
KE200 detected a CRC error while writing to a Fleetkey in the keypad mode.