Gasboy FMS KE200 - Manual (Page 43)

MDE-4465A KE200 Key Encoder/Maintenance Terminal Operation Manual · October 2007 Page 37
Signing Off of the Terminal KE200 Setup - Terminal
Signing Off of the Terminal
To sign off from the terminal, type EXIT and press ENTER.
The data terminal for KE200 communication is set to a 5 minute time-out. This means that if
the terminal does not register any input for 5 minutes, it automatically signs off.
Lost or Forgotten Password
If you forget your sign-on password, the KE200 system provides a way for you to gain system
access.
1 Place the manager’s key in the “ENCODE” position.
2 At the “SIGN ON:” prompt, type “GASBOY” and press ENTER. The asterisk prompt
appears.
3 Re-load your sign-on password using the “LOAD SIGNON” command.
Setting Up the KE200
The first time you use your Key Encoder/Maintenance Terminal, you must perform the
following steps in order to load your system with the necessary data to perform your
processing:
1 With the Manager key inserted and in the idle position, turn the power switch located on the
left side of the face to “ON”. The KE200 displays the current date and time (these were set at
the factory to Eastern time).
2 Sign on to the terminal as described in “Signing On to the Terminal” on page 36 .
3 At the asterisk command prompt, use the “LO SI” command to load your sign-on code
(password) if you have not already done so.
4 Type “SETUP” and press ENTER. “SETUP” is a batch program containing all commands
needed to load the KE200 for operation. Some commands are not included; see the
“Setup” on
page 58 for details. If desired, you can also run all the load commands manually. The
commands to be run are:
- “LO DA”, loads date and time
- “LO SY”, loads the system ID. This must match the system ID of your FleetKey system.
- “LO ST”, loads the station ID.
- “LO PI”, loads the working key (for pin calculation). This must match the working key
of your FleetKey system.
- “LO CO”, loads country options for units and date format.