Gasboy FMS KE200 - Manual (Page 55)

MDE-4465A KE200 Key Encoder/Maintenance Terminal Operation Manual · October 2007 Page 49
Load Transactions (LO TR) KE200 Setup - Terminal
Load Transactions (LO TR)
Use “LOAD TRANSACTIONS” to load a starting number for your maintenance transactions.
For your transactions to start at the number you desire, this command value must be set to the
number before the one you wish to start at (for example, if your first transaction is to be
number 1, set this command to zero). You can check the current values for “FIRST”, “LAST”,
and “NEXT” transactions by running the “STATUS” command.
To use Load Transactions to load a starting number for maintenance transactions, proceed as
follows:
1 At the asterisk prompt, type “LO TR” and press ENTER. The system responds: “LOAD
TRANSACTION NUMBER?”.
2 Type the number preceding the number at which you wish to start and press ENTER.
Print Country (PR CO)
Use “PRINT COUNTRY” to print the current settings for your country options.
At the asterisk prompt, type “PR CO” and press ENTER. The system displays the current
settings as shown below.
“UNITS = MILES
DATE FORMAT = MM/DD/YY”