Gasboy FMS KE200 - Manual (Page 12)

System Overview Communications
Page 6 MDE-4465A KE200 Key Encoder/Maintenance Terminal Operation Manual · October 2007
The following table contains Poll Address Switch Settings for SW1-1 through SW1-4.
Address SW1-1 SW1-2 SW1-3 SW1-4
01 CLOSED CLOSED CLOSED CLOSED
02 OPEN CLOSED CLOSED CLOSED
03 CLOSED OPEN CLOSED CLOSED
04 OPEN OPEN CLOSED CLOSED
05 CLOSED CLOSED OPEN CLOSED
06 OPEN CLOSED OPEN CLOSED
07 CLOSED OPEN OPEN CLOSED
08 OPEN OPEN OPEN CLOSED
09 CLOSED CLOSED CLOSED OPEN
10 OPEN CLOSED CLOSED OPEN
11 CLOSED OPEN CLOSED OPEN
12 OPEN OPEN CLOSED OPEN
13 CLOSED CLOSED OPEN OPEN
14 OPEN CLOSED OPEN OPEN
15 CLOSED OPEN OPEN OPEN
16 OPEN OPEN OPEN OPEN
Note: The poll address is the same for both Port 1 and Port 3 (internal modem port).
Position 5 on switch bank SW1 is used to select the communications mode for Port 1. When
position 5 is closed, the port operates in the Standard Terminal mode providing operator
prompts and messages. Activity through Port 1 is also sent to the logger port while Port 1 is in
the Terminal mode.
When position 5 is open, the Computer Mode interface is selected for Port 1. While in the
Computer mode, the port only responds to Computer mode command packets. Gasboy PC
software uses Computer mode to communicate with the KE200. Activity through Port 1 is not
sent to the logger port while it is set for Computer mode.
SW1-5 Definition
CLOSED Terminal mode selected for Port 1
OPEN Computer mode selected for Port 1